Visualizing US Oil & Gas Production (Through November 2019)

This article contains still images from the interactive dashboards available in the original blog post. To follow the instructions in this article, please use the interactive dashboards. Furthermore, they allow you to uncover other insights as well.

Total US Oil Production — November 2019

Visit ShaleProfile blog to explore the full interactive dashboard

These interactive presentations contain the latest oil & gas production data from 120,328 horizontal wells in 12 US states, through November 2019. Cumulative oil and gas production from these wells reached 12.9 billion bbl and 145 Tcf of natural gas. West Virginia is deselected in most dashboards, as its production data is only up-to-date through September. Oklahoma is for now only available in our subscription services.

Oil production from these wells set another record in November, at over 7.6 million bo/d (after upcoming revisions). The over 10 thousand horizontal wells that came online in 2019 contributed half of this supply (3.8 million bo/d), as is visualized by the dark blue area in the graph above.

Gas production also set a new high (toggle product to ‘Gas’ to see this), at just over 68 Bcf/d. Because natural gas production declines slower than oil, you’ll note that for this product the 2019 wells only contributed about 1/3rd of supply in November.

Well performance in the oil basins edged higher in 2019 (“Well quality” tab), but not by as much as would be expected from the average increase in lateral lengths alone.

The output of the 10 largest operators can be found in the final tab (“Top operators”).

The ‘Advanced Insights’ presentation is displayed below:

Ultimate Recovery US Oil Production — November 2019

This “Ultimate recovery” overview shows the relationship between production rates and cumulative production over time. The oil basins are preselected and the wells are grouped by the year in which production started.

More recent and granular data can be obtained if you change the “Show wells by” selection to the quarter in which these wells began production. The wells from the 3rd quarter last year had the highest initial productivity so far.

In the major tight oil basins, about 2 barrels of water are produced together with each barrel of oil, on average. In the following dashboard, taken from ShaleProfile Analytics, we can analyze the water production from all the horizontal wells:

Water production and water/oil ratios in the major tight oil basins. Hz wells since 2008 only.

The map on the left side shows the location of all horizontal wells and they are colored by the water/oil ratio in the most recent month (more red is more water). As you can see, most water is produced in the Permian, followed by the Bakken.

The top-right chart shows the total oil & water production from these wells, as well as the average water/oil ratio (“WOR”, in yellow, right-hand side axis).

The bottom-right chart displays the water/oil ratio by months on production, colored by vintage. Here you can see that newer wells produce more water, on average (one obvious reason is the shift towards the Permian).

Early next week we will have a new post on North Dakota, which just released January production data for most wells (which we expect to have in our services later today or at least tomorrow). We also aim to finish a new dashboard on gas flaring this week, which I hope to share then.

Production data is subject to revisions. For these presentations, we used data gathered from the sources listed below.

Visit our blog to read the full post and use the interactive dashboards to gain more insight: https://bit.ly/2ImFXZ2

Follow us on Social Media:

Twitter: @ShaleProfile

LinkedIn: ShaleProfile

Facebook: ShaleProfile

Dedicated to developing the best Visualization & #Analytics solution for the #Shale #Oil & #Gas industry. Follow us and gain insights on Shale Production.